Scell-it E-649RP, Operation Manual

Page: 4 / 40

EN
FR
PL
CZ
IT
E-649RP / User manual
4
TOOL MAINTENANCE
5) To test the tool stroke. If the stroke still not enough as it should be, it means there could be some air in the oil
cylinder (#13) when you refilling the oil to the tool. Then the extra air needs to be released from the tool.
To connect the tool with air supply, to pull the tool trigger (#46) 6 or 7 times, then loosen the screw (#11) , let
the extra air leaking out, then screw on the screw (#11) tight again.
1) To remove the screw (#11) by hexagon wrench.
3) To screw the oil inject adaptor (on oil injector set
in the accessories pack) into the hole where
screw (#11) removed.
4) To use the oil injector (in the accessories pack)
to inject the oil slowly until not able to refill
(approx. 15ml ), to remove the injector and its
adaptor, then clean the oil on the tool and tightly
screw on the screw (#11) back to the tool.
2) To connect the air supply and to cover some
cloth over the hole where the screw (#11)
removed, then to pull the trigger (#46) and the
oil will be leaked out from the tool.
If there is no lubricating device connected in the air distribution, daily and before starting work, for better
performance of the tool, add a few drops of hydraulic oil on the inlet of the air adaptor (#50) of the tool in order to
reduce the frictions of the tool parts since the oil will be blown inside the tool when tool operates.
After certain period of use, the tool stroke might be reduced, it shows the hydraulic oil of the pneumatic tool is
necessary to be refilled or changed: