Scell-it E-649RP, Operation Manual

Page: 3 / 40

EN
FR
PL
CZ
IT
E-649RP / User manual
3
Please refer to the TOOL EXPLOSIVE ILLUSTRATION and the PARTS LIST in this manual in order
to have a good understanding of the tool parts described. The descriptions of the tool parts
appear in this manual are in
italics with the parts position numbers corresponding to the tool
explosive illustration.
1) This pneumatic powered tool should be worked with compressed air supply. It is recommended to use the air
hose with diameter bigger than 8 mm;
2) To check the compressed air pressure within the specified range between 0.5Mpa and 0.7Mpa, and to connect
the air hose adaptor onto the tool air adaptor (#50). The air adaptor has its different versions in different
countries and areas, normally the tools are equipped with the correct version as default, in case the air adaptor
does not apply in your air supply hose adaptor, contact the tool distributor(s);
3) To change and use correct nosepiece (#1) according to the type, head formation and size of the rivet to be
set. This tool is equipped with nosepieces as described in TOOL CAPACITY . Follow the steps below to change
the nosepiece (#1) :
GETTING START TO WORK
a) To remove the air supply hose from air adaptor (#50) .
b) To use the wrench (in accessories pack) to remove the
nosepiece (#1) from the tool.
c) To select the correct nosepiece in accessories pack and
screw on to the tool, using the wrench to fix it firmly
on the tool.
TOOL OPERATION FOR SETTING BLIND RIVETS
1) After start-up preparations, to put the rivet into the nosepiece with the rivet mandrel, and holding the tool to
insert the rivet into the pre-drilled hole of the work pieces where the work pieces needs to be fastened;
2) To pull the tool trigger (#46) to set the blind rivet in its position on work piece;
3) After setting the rivet, the rest mandrel of the rivets will be sucked into the mandrel collector (#25)
automatically. Be sure to empty the mandrel collector (#25) in time otherwise the tool can not release the
mandrel properly.
4) The air power of sucking the rest mandrel can be adjusted bigger or smaller, by the knob on back of the tool
visible when the mandrel collector removed:
5) On the air adaptor hose (#51)
equipped for this tool, there is
a sliding switch for pause the air
supply. To switch off for saving air.
4) To install the mandrel collector ( #25 , in accessories pack) on the back of the tool: