Scarlett SC-VC80R12, Instruction Manual

Page: 6 / 28

IM021
6 SC-VC80R12
SPIRAL CLEANING MODE BUTTON

Press spiral mode cleaning button, the device will move in spiral trajectory from starting point and back. This mode is most
suitable for heavily dirty areas.
START/PAUSE button

Press the start/stop button once to stop the cleaning, click again to resume the cleaning

SLEEP MODE

Device turns on sleep mode after 5 minutes pause, press any control button to restart working.
CARE AND CLEANING
DUST BIN CLEANING

Pull up the upper cover directly.

Take out the dust bin out of the vacuum cleaner.

Open the lid of dust bin by putting your finger into the dust bin groove and gripping to take it out

Take out the inner filter

Empty the dirt in the dust bin

Rinse the dust bin with tap water. Do not wash it in washing machine, dish-washing machine or other machine.

Periodically clean the filter with a soft bristle brush.

Reinstall the filter and the dust bin lid once they get dried.

Put back the dust bin into the cleaner
ATTENTION:

After repeated use for some time, dirt and dust might accumulate around the intake of the product, to ensure its best cleaning
efficiency and constant airflow it should be cleaned periodically Vacuum cleaner or cord should never be immersed into water
or any liquids.

WARNING!

Be sure to clean the container after each cleaning.

Never use the vacuum cleaner without installed filter and with damaged or dirty filter. Otherwise, dust will fall into the motor
and cause damage to the vacuum cleaner.
 Don’t use the vacuum cleaner if the container is filled to the mark “MAX”. When the container is filled, dirty air clogs up the
vacuum cleaner filter and the engine can overheat and disable.
 Don’t use the vacuum cleaner for cleaning of material debris such as cement, whitewash, plaster, metal shavings and etc.
These particles cause to the engine damage.
 Don’t wash vacuum cleaner parts in a dishwasher or a construction machine.
BATTERY REMOVAL

The battery must be removed from the appliance before its disposal.

When removing the battery, the appliance must be disconnected from power supply.
STORAGE

Fulfil all the steps from parts CARE AND CLEANING.

Store the unit in dry cool place or in the original box.
TROUBLESHOOTING

If all s
olutions given above don’t work for you, please re-set the robot by switching on the power button
Problem Possible Cause Solution
Red LED stays after power on
1. Battery Low condition
2. Main body is picked up
1. Recharge the battery
2. Re-place the robot on the floor
Vacuum on but can not
collect dirt and hair
1. The dust bin is full
2. The filter is not installed correctly
1. Clean the dust bin
2. Re-install the filter correctly
The product is moving
backwards after being started 1. The product is on dark color floor
2. Anti-drop sensor light was
covered
1. Put the robot on light color floor.
2. Clean anti-drop sensor light.
LED indicators flash in blue after 2hrs
charging
Power supply might been cut off during
charging
The robot can be operated if the
battery has been fully charged for
2hrs
The side brushes crooked, not
good to sweep
Being used for a long time
If it becomes crooked, please scald
it in hot water to recover it to its
original shape
The product cannot start
1. Battery is not installed properly
2. Battery low
3. The robot is under protection status
1. To install the battery correctly
2. To have the battery fully
charged(turn off the cleaner first)
3. To re-set the robot
The symbol on the unit, packing materials and/or documentations means used electrical and electronic units
should not be toss in the garbage with ordinary household garbage. These units should be pass to special receiving
point.