13
7.0 OPERATING PV 35 HORIZONTAL
Before positioning the machine it is necessary to leave enough working area for the proper
bending operations such as: extraction of the cylindrical profile, feeding of the semi product,
bending of big diameters.
If you have no alternative to install the machine in a broad area but a low-height area, then
there is a solution to this problem as shown in figure 2.
To set the machine horizontally, follow these steps:
Wrap a
belt capable of carrying at least 500 kg around the top roll’s
shaft (shown by
in fig.1).
•
Lift the machine slowly by means of a forklift or a crane with hook.
•
When you are satisfied that you have lifted the machine to the
degree that only the corner shown by
in figure 2 touches to the
floor, rotate the machine right slowly with the help of a person so that
the mass center of the machine tend to be at the right side of that
corner.
•
After that, slowly lower the machine.
Attention:
Do not wrap the belt around the top roll adjustment screw so that it may be bent or its teeth
may be damaged.
Figure 2
Figure 3 shows an example of horizontal working.
Figure 3
1.0 F
i
g
u
r
e
1
Summary of Contents for PV 35
