COMPACT 36
COMPACT 36
Operator’s manual for drilling machine
- 13 -
6. MAINTENANCE AND SERVICE
-
COMPACT 36 machine is equipped with a maintenance free system for
adjustment of guide slides.
-
Check condition of carbon brushes after every 100 hours of work.
Replacement of brushes is possible without removal motor unit from the unit. (see
point 6.1) Other repair work should be done only by authorized service points,
appointed by distributor.
-
To prevent the machine from rusting (especially when used outdoors) all steel
parts should be covered with thin layer of grease film.
WARNING: The safety strap and web must be replaced after
every occurrence when machine went off piece and hanged or
pulled on the strap and web.
If work piece thickness is less than 3/16” (5mm), the magnetic adhesion detection
system will not allow to start then motor. The same system will turn OFF the motor
after even a slight move of magnetic base.
If customer needs to use the drill on thin (less than 3/8”) steel it is possible to
have that system switched OFF. Above can be performed at end users own
responsibility and by specialized service only.
WARNING: Work with magnetic adhesion system switched OFF
must be done with extreme caution. Use of COMPACT 36 drill on
steel thinner than 3/16” (5 mm) is not allowed by the manufacturer.
Caution:
In the case that the machine falls on a hard surface,
from a height, is wet or is subjected to other unfortunate events that
could affect its technical state - work should be terminated
immediately and the machine should be sent to service for
inspection as soon as possible.
Detailed PARTS LIST of Drilling Machine
COMPACT 36
is available. Please enquire !