Packaging/Old appliance
This marking indicates that this product should not be dis-
posed with other household wastes throughout the EU. To
prevent possible harm to the environment or human
health from uncontrolled waste disposal, recycle it respon-
sibly to promote the sustainable reuse of material re-
sources. To return your used device, please use the collection systems
or contact the retailer where the product was purchased. They return
and can take this product for environmental safe recycling.
Warning
!
This appliance is intended to be used in househould and applications
such as Staff kitchen areas in shops, offices and other working environ-
ments;
• Farm housed;
• By clients in hotels, motels and other residential type environ-
ments;
• Bed and breakfast type environments;
• Areas for communal use in blocks of flats or in launderettes;
Installation
Before installing the machine, the location characterized as follows shall
be selected:
Installation area
Stability is important to prevent the product from wandering!
• Make sure that the product should not stand on the power cord.
• Rigid, dry, and level surface
• Avoid direct sunlight
• Sufficient ventilation
• Room temperature is above 0
℃
• Keep far away from the heat resources such as coal or gas.
• Minimum 20 mm space from walls to appliance
Unpacking the washing machine
Warning!
Packaging material (e.g. Films, Styrofoam) can be dangerous for chil-
dren. There is a risk of suffocation! Keep all packaging well away from
children.
1 Remove the cardboard box and styrofoam packing.
2 Lift the washing machine and remove the base packing. Make sure
the small triangle foam is removed with the bottom one together.
If not, lay the unit down with side surface, then remove the small
foam from the unit bottom manually.
3 Remove the tape securing the power supply cord and drain hose.
4 Remove the inlet hose from the drum.
Remove transport bolts
Warning!
You must remove the transport bolts from
the backside before using the product. You
will need the transport bolts again if you
move the product, so make sure you keep
them in a safe place.
Please take the following steps to remove
the bolts:
1 Loosen 4 bolts with spanner and then remove them.
2 Stop the holes with transport hole plugs.
3 Keep the transport bolts properly for future use.
Levelling the washing machine
Warning!
The
lock nuts
on all four feet must be screwed tightly against the hous-
ing.
• Check if the legs are closely attached to the cabinet. If not, please
turn them to their original positions tighten the nuts.
• Loosen the lock nut turn the feet until it closely contacts with the
floor.
• Adjust the legs and lock them with a spanner, make sure the ma-
chine is steady.
Connect Water Supply Hose
Warning!
• To prevent leakage or water damage, follow the instructions in this
chapter!
• Do not kink, crush, modify or sever water inlet hose.
• For the model equips hot valve, connect it to hot water tap with hot
water supply hose. Energy consumption will decrease automati-
cally for some program.
1 Connection between water supply and inlet hose.
2 Connect the other end of inlet pipe to the inlet valve at the backside
of product and fasten the pipe tightly clockwise.
Drain Hose
Warning!
• Do not kink or protract the drain hose.
• Position drain hose properly, otherwise damage might result of wa-
ter leakage.
There are two ways to place the end of drain hose:
1 Put it into the water trough.
2 Connect it to the branch drain pipe of the trough.
