Cleaning The Inlet Filter
Note: Inlet filter must be cleaned if there is less water.
Washing the filter in the tap
1 Close the water supply
2 Remove the water supply hose from the tap.
3 Use an old tooth brush or similar small brush to clean the filter.
4 Reconnect the water supply hose.
Washing the filter in washing machine:
1 Screw off the inlet pipe from the backside of the machine.
2 Pull out the filter with long nose pliers and reinstall it back after
being washed.
3 Use an old tooth brush or similar small brush to clean the filter.
4 Reconnect the inlet pipe.
Note:
It is possible to pull out the filter and wash it separately.
Clean The Detergent Dispenser
Press down the arrow location on softener cover
inside the dispenser drawer.
Lift the clip up and take out softener cover and
wash all grooves with water.
Restore the softener cover and push the drawer
into position.
1
Pull out the dispenser drawer with press the A
2
Clean the dispenser drawer under water
3
Clean inside the recess with an old toothbrush
4
Insert the dispenser drawer
Note!
Do not use alcohol,solvents or chemical products
to clean the machine.
Cleaning The Drain Pump Filter
Warning:
Be careful of the hot water!
• Allow detergent solution to cool down.
• Unplug the machine to avoid electrical shock before washing.
• Drain pump filter can filter the yarns and small foreign matters from
the washing.
• Clean the filter periodically to ensure the normal operation of
washing machine.
Open the lower cover cap
Rotate 90°C and pull out the emergency drain hose, and take off the
hose cap
After water runs out,reset the drain hose
Open the filter by turning to the counter clockwise
Remove extraneous matter
Close the lower cover cap
Caution!
• Make sure that valve cap and emergency drain hose are reinstalled
properly, cap plates should be inserted aligning to hole plates oth-
erwise water may leak.
• Some machines don’t have emergency drain hose, so step 2 and
step 3 can be skipped. Rotate lower cover cap directly to make wa-
ter run into basin.
• When the appliance is in use and depending on the programme se-
lected there can be hot water in the pump. Never remove the pump
cover during a wash cycle, always wait until the appliance has fin-
ished the cycle, and is empty. When replacing the cover, ensure it
is securely re-tightened.
