14
User manual SCAIME:
NU-eNodTouchM-E-0815_196774-B
2.2.2.
Brightness/contrast control
•
To display the Brightness Control Bar on the display unit, enable the setting [Show Brightness/Contrast Control Bar] in
[Display Settings] (§2.2.1)
•
Touch the upper right then left corners, or the Bottom left and right corners of the display in 0.5 seconds.
•
To end Brightness/Contrast Control mode, touch the [ X ] on the Brightness/Contrast Control Bar.
2.2.3.
Peripheral – Device PLC Settings
Menu Input
Parameter
Description
Default
Communication
SIO Type
Set the Communication type
RS422/485 (2wire)
Speed
Communication Speed : Should be set
according to eNod4 communication settings
19200
Data Length
8
Parity
[None]
Stop Bit
2
Flow Control
[None]
Time out (s)
1
Retry
1
Wait to send (ms)
10
Device
Device Name
eNod4_1 - eNod4_6
Slave Address
(Decimal)
eNod4 slave address : Should be set according
to eNod4 communication settings
1 - 6
Max. Query Read Input
Reg.
30
Max. Query Read
Holding Reg.
30
Max. Query Write
Holding Reg.
30
Note: Never change the parameters in grey
2.2.4.
Password menu
Menu Input
Parameter
Description
Default
System Password
System Password
The password setting is used when changing
to the Initialize Memory or offline mode
screens.
-
Security Password
Security Password
Not used
-
Note: Never change the parameters in grey
2.2.5.
Initialize menu
Menu Input
Action
User memory
Deletes all data in the display unit's internal memory.
Enter System password to operate, or 1101 (default password)
Backup Data
Clears all the data stored in the display unit's backup memory.
Enter System password to operate, or 1101 (default password)
Note: Never use the commands in grey: You’ll lost the SCAIME eNodtouch application
