![background image](http://html1.mh-extra.com/html/scag-power-equipment/turf-tiger-smst-72a/turf-tiger-smst-72a_operators-manual_1205952034.webp)
29
R
Section 6
B. 3-1/2" Position - (See Figure 6-9). Baffle is installed
using the middle set of holes on the front baffle welded
inside the cutter deck. Can be used for general purpose
cutting. Placing the Custom-Cut Baffle in the 3-1/2"
position gives a good mix of cutting performance in all
types of grass.
C. 4" Position (factory setting) - (See Figure 6-9). Baffle
is installed using the bottom set of holes on the front
baffle welded inside the cutter deck. Placing the baffle
in the 4" setting will enhance fall cutting (leaf pickup)
and reduce cutter deck "blowout".
To adjust the Custom-Cut Baffle height:
Place the cutter deck in the transport position.
1.
Remove the hardware securing the Custom-Cut
2.
Baffle to the cutter deck. See Figure 6-9.
- NOTe -
Hardware location used in the illustrations are for
reference only. Location of hardware may vary
depending on cutter deck size.
Move the Custom-Cut Baffle to desired position. See
3.
Figure 6-9.
Reinstall the mounting hardware as shown. Torque
4.
hardware to 39 lb-ft.
7-POSITION CUSTOM-CUT BAFFLE
ADJUSTMENT - CURRENT PRODUCTION
A. 3-1/2" or 3-3/4" Position - (See Figure 6-10). For
very tall, wiry or tough-to-cut grass.
B. 4" (factory setting), 4-1/4" or 4-1/2" Position - (See
Figure 6-10). For general purpose cutting. This gives
the best mix of cutting performance in all types of
grass.
C. 4-3/4" or 5-1/4" Position - (See Figure 6-10).
Placing the baffle in either the 4-3/4" or 5-1/4" setting
will enhance fall cutting (leaf pickup) and reduce cutter
deck "blowout".
To adjust the Custom-Cut Baffle height:
Place the cutter deck in the transport position.
1.
Remove the hardware securing the Custom-Cut
2.
Baffle to the cutter deck.
- NOTe -
Hardware location used in the illustrations are for
reference only. Location of hardware may vary
depending on cutter deck size.
Move the Custom-Cut Baffle to desired position. See
3.
Figure 6-10.
Reinstall the mounting hardware. Torque hardware to
4.
39 lb-ft.