18
SBS System – SB-1000 Operation
Additional iterations of the Solution phase (Trim Phase) can be performed if the balance solution is
unsatisfactory. The box on the left side of the screen contains the equivalent single point total balance
solution. The digit to the left of the box indicates the phase (1-Zero, 2-Test, 3=Solution, 4 or higher=Trim).
The higher this number gets, the more Trim balance operations have been performed since the last
determination of a correct Zero and Test phase.
— —
It is possible at the Solution Phase that a balance solution is
difficult to achieve, at which time one of these screens may be
displayed instead of the Solution screen.
The top image indicates that bigger weights should be used.
Press
button to return to Apply Weights screen for an
opportunity to use a larger weight and repeat the Test phase.
The bottom image indicates that the compensation numbers are
very large or small for accurate display and the weight units in
use may need to change.
Press
button to return to the Apply Weights screen without
making any changes.
If changes are made, a new complete balance operation should
be run by pressing
.
Pressing
will advance to the next step in the phase, the Start Spindle screen. The
symbol flashes as a
reminder. Starting the spindle will also advance to the next screen.
3) Start Spindle – This screen requests the operator to start the spindle. The
icon and the “RPM” both
flash as a reminder. The control stays on this screen until it senses the spindle is up to constant speed. Then
the screen advances to the Measure screen. The
symbol indicates that the weight locations will be
displayed for review by pressing the
button (will go back to Apply Weights screen).
4) Measure – The control measures the new vibration level. The operator should wait for the RPM and
vibration to stabilize then press
button to advance to the next screen. The
symbol flashes as a
reminder. If the balance level is below the Limit, then the balance process is complete and the next screen
displayed is the Main screen. Otherwise the control will advance to the Stop Spindle screen of the next
phase. Press
button to back up and show the Apply Weights screens in order to review the last weight
changes.
