MW-1000™ User Guide
39
21.
How do I connect to MW-1000 from my Windows PC?
Please follow the instructions listed below to connect to your MW-1000 board.
Open Putty application.
Check out '9.1.2 Putty
–
Connecting to MW-1000 terminal' section for
installation/usage instructions.
Provide MW-1000's IP-address and port-number in Putty configuration section.
Select "Yes" button in the popup. In case if you get a security prompt (popup) in putty -
stating certificate is not verified.
Enter username in the shell (putty-cmd)
Enter password in the shell (putty-cmd)
On entering correct user-credentials, MW-1000 accepts the connection request, and you can
access MW-1000 command-line-interface (CLI)
22.
What is my board's IP address/subnet?
By default, Once your MW-1000 is assigned an IP address of 192.168.100.1 (subnet
192.168.100.*). In case, if the IP-address is updated (or) if you are not able to view the MW-
1000 on its default IP-address. Follow the instructions listed for identifying the new-IP-address.
Connect your (Linux) PC using a serial cable to management port on MW-1000.
Open terminal on your (Linux) PC.
Use the minicom command to access MW-1000 via serial-port. (in Linux environment)
> minicom
In windows environment, use putty to connect via serial port. For putty-configuration
details, refer to '9.1.2 Putty
–
Connecting to MW-1000 terminal' section.
Enter the username and password for entering MW-1000.
Once you are logged-into the MW-1000, enter the following command for identifying
the IP-address.
> ifconfig eth0
Check-out the value for 'inet addr'. ex: 'inet addr:10.0.0.191'
23.
Where can I find my USB drive files?
Please refer to section ' USB' for details on mounting location.
24.
How to mount/unmount USB?
Refer to section 7 'Command Line Interface Commands' for mount/unmount commands.
25.
How do I connect to MW-1000 from my Linux PC?
In case Board is inaccessible post reboot, connect to MW-1000 using either a microUSB cable or
via serial-cable (to management port)
Follow the instructions mentioned below to recover from failure:
Connect microUSB cable to console port of MW-1000.
Refer to section 9.2.2 'Connecting to MW-1000 via microUSB port'
Check & update DHCP configuration in network file at /etc/config/network
Initiate DHCP process by executing "udhcpc" in terminal
> udhcpc
