Sauter Components RDT 300 F001, User Manual

Page: 39 / 64

Description of parameters 2 - 35
7000928003 R4
Sauter Components
dXi.
Unit of
measurement Xi
Access: Service level
The actual value's unit of measurement for the display. This stipulation applies simultaneously for all associated parameters,
such as setpoint, proportional band and shift parameters.
Possibilities:
N.B.: If ‘free unit of measurement’ is selected, no unit-of-measurement symbol is shown in manual and automatic modes.
End End value for the flow temperature when the ETF is on
Access: Manual
End value for the setpoint for the flow temperature when the ETF is on
ER
Daily
increase in flow temperature when the ETF is on
Access: Manual
Amount by which the setpoint for the flow temperature is increased each day when the ETF is active.
ETF Dry flooring function
Access: Service level
Activates the dry flooring function; indicated by a flashing symbol in automatic operation. When the ETF has been started, the
controller initially regulates a flow temperature that is set using the ST parameter. At 02:00 hrs, the setpoint for the flow tempe-
rature is raised by the amount that has been selected using the Er parameter. The flow temperature is raised each day until
the value that was selected using the End parameter has been attained. On the following day at 02:00 hrs, the ETF finishes
and the controller changes to automatic mode. If, because of the values of the ST and Er parameters, the setpoint for the flow
temperature is higher than the value for the End parameter, then the value of the End parameter is used in order to control the
flow temperature.
.F1 End of shift
Access: Manual
This determines the end point of the shift on the command module. Also see FP and WS.
Unit of measurement
°C
g/kg
% kJ/kg
% r.h. - (free unit of
measurement)