2
109872
RIGHT
MOLDING (I)
LEFT
MOLDING (J)
TOP (E)
NOTE:
Before beginning this step, separate the 1--1/2” FLAT HEAD SCREWS (Y) and 1--1/8” FLAT
HEAD SCREWS (CC). Do not confuse these SCREWS.
-
Position the
TOP (E)
as shown with the unfinished surface facing up.
-
Fasten the
RIGHT MOLDING (I)
and
LEFT MOLDING (J)
to the
TOP (E)
as shown. Use seven
1--1/8” FLAT
HEAD SCREWS (CC)
through the holes in each
MOLDING
and into the pre--drilled holes in the
TOP.
IMPORTANT: Do not overtighten the SCREWS. The heads of the SCREWS should be even with the
surface of the MOLDINGS.
NOTE:
Be sure the finished surfaces of the RIGHT and LEFT MOLDINGS are facing up. The
MOLDINGS will set in from the edges of the TOP. The angled ends of the MOLDINGS should
be positioned toward the same end of the TOP that has the large hole.
When fastened, the
MOLDINGS
set in from
the edges of the
TOP.
Finished
surface
Finished
surface
Unfinished
surface
Large
hole
Angled
end
1--1/8” FLAT HEAD SCREW (CC)
(14 used in this step)
www.sauder.com/services
