GSM LT-1
SATEL
17
one short (S)
– antenna signal strength = 1,
two short (SS)
– antenna signal strength = 2,
three short (SSS)
– antenna signal strength = 3,
four short (SSSS)
– antenna signal strength = 4 (maximum).
[1][5][*][*][#]
–
check telephone status
. The module informs the user about its status.
The signaling is same as that of the STAT LED. The following answer beeps are possible:
four short (SSSS)
– no SIM PIN code,
three short (SSS)
– wrong SIM PIN code,
short and long (SL)
– SIM PUK code required,
two short (SS)
– no communication with GSM telephone,
oneshort (S)
– module operation OK,
two long (LL)
– module restart after power-up,
two short and one long
(SSL)
– PH-SIM PIN code required,
eight short
(SSSSSSSS)
– no SIM card,
three long (LLL)
– SIM card damaged,
four beeps of diminishing length (LlSs)
– SIM card busy,
long, short, long, short (LSLS) –
incorrect SIM card,
three short and one long
(SSSL)
– SIM PIN2 code required,
four short and one long
(SSSSL)
– SIM PUK2 code required,
one long, three short and one long
(LSSSL)
– other error.
[1][6][*][*][?][?][?][?][?][?][?][?][#]
–
enter
PUK code
(8 digits) into the SIM card. This
function can only be performed when the module status indicates (by LED or beeps) that
the PUK code is required. This code is not stored anywhere, but after entry it is transferred
to the SIM. When the PUK is entered and the telephone is unblocked, the PIN code
currently programmed in the module settings will be loaded into the SIM memory.
Note:
After entering the PUK code, the SIM card will get unlocked and its PIN code
will be
changed
to that currently programmed in the module memory. In order to avoid such
a situation, the PIN code entered by user into the module memory must be identical to
that saved on the SIM card. The DLOAD program enables viewing the PIN code
currently programmed in the module, to prevent the card from being blocked.
Entry of a correct PUK code will be confirmed by three short beeps (SSS) – this
confirmation will appear after a few seconds' delay because of the data processing in the
GSM telephone. If the PIN code is not entered into the module, the function will not be
executed and the device will generate two long beeps (LL).
[1][7][*][*][?][#]
–
deenergizing
the telephone line together with signaling fault at the FLT
output:
0 – do not switch off voltage on telephone line terminals,
1 – switch off voltage on telephone line if FLT is active
(programming mode – if it was turned on before activating FLT, it will be operative, but
only until hang-up).
[1][8][*][*][?][#]
–
generating the routing signal
(sound signal for setting up connection):
0 – routing signal OFF,
1 – routing signal ON.
[1][9][*][*][?][#]
–
test transmission
. The function enters the period of CLIP test
transmission in a simplified way. The following values can be entered:
0 – no test transmission,
1 – test transmission period
2 h 58 min,
