Satel GSM LT-1, User Manual

Page: 18 / 24

User Manual GSM LT-1 16
[0][8][*][*][?][?][#]
–
modem standard format
(2 digits) – the format in which the module
will communicate with the modem of service/user computer. The format code is to be
entered as two digits according to the table below:
format code modem format
00 auto
01 300
V.21
02 1200 V.22
03 1200/75 V.23
04 2400 V.22bis
05 2400 V.26ter
06 4800 V.32
07 9600 V.32
12 9600 V.34
14 14400 V.34
65 300 V.110
66 1200 V.110/X.31
68 2400 V.110/X.31
70 4800 V.110/X.31
71 9600 V.110/X.31
75 14400 V.110/X.31
[0]9][*][*][?][#]
–
RS-232 port speed.
Parameter defining the rate of data transfer between
the module and the control panel/computer. You should enter a digit to define one of the
following rates:
0 – 4800 bps,
1 – 9600 bps,
2 – 19200 bps.
[1][0][*][*][?][#]
–
SMS center international number
. The option indicates whether the
programmed SMS center number is a full international number.
0 – no (for local networks),
1 – yes (recommended).
[1][1][*][*][?][#]
–
Fax/Modem
. Option indicating whether the user permits a modem
transmission to be carried out by the module. You should program one of the following
values:
0 – transmission disabled,
1 – transmission enabled.
[1][2][*][*][?][?][?][?][?][?][#]
–
access code
(6 digits) for programming the module by
means of a telephone set. The [1][2][*][*][#] sequence will delete the code i.e. deny the
access to programming. When you delete the code and quit the programming mode, you
will only be able to change the settings and restore the code by using a PC computer and
the DLOAD10 program.
[1][3][*][*][1][2][3][4][#]
–
restore default settings
(the default access code for module
programming is 123456).
[1][4][*][*][#]
–
check antenna signal strength
. The module, by means of handset beeps,
informs the user about the level of received antenna signal. The signaling is same as that
of the SIG LED. The following answer beeps are possible:
two long (LL)
– antenna signal strength = 0,