SATEL ACU-220
15
signal repeaters can be registered to the controller). Leave this field blank if the device is
to communicate directly with the controller. If the device is to communicate with the
controller via the radio signal repeater, enter the number of position occupied by the radio
signal repeater on the list of wireless devices (the radio signal repeater takes up two
positions on the device list – enter the number of the first of them).
Filter
– the number of consecutive communication periods without connection between the
device and the controller after which loss of communication with the device will be
reported. You can enter values from 0 to 255. Entering 0 disables the check for device
presence in the system.
If the system is to meet the EN50131 requirements for Grade 2, loss of communication
with the device must be reported within 20 minutes at the latest. Therefore, when
entering the number take into account the frequency of periodical communication
(“Communication period” parameter or “ECO” option).
Configuration
– for some devices, you can configure additional parameters and options (see
“Configuring devices using the ABAX 2 Soft program” p. 44).
Temp.corr.
– you can correct the temperature information sent by the device by up to
±3.5°C.
ECO
– if this option is enabled, periodical communication with the device takes place every
3 minutes. Thus the battery life can be extended up to four times.
Remember that with the “ECO” option enabled for:
detector – delay between the change of control input state and switch-over of the
detector operating mode (active/passive) can be up to three minutes,
ASP-215 siren – delay in starting / stopping the signaling can be up to three minutes.
Buttons
click to add new device (see “Adding new wireless devices” p. 30).
click to remove selected device (see “Removing wireless devices” p. 30).
5.5 Status
Controller status
Inputs
Information about the state of controller inputs:
[green] – input in normal state.
[red] – input activated.
Jamming
Information about radio communication jamming:
[yellow] – communication is jammed,
[gray] – communication was jammed.
Level
– level of radio communication jamming signal.
Count
– number of radio communication jamming cases.
