20 ACU-220
SATEL
Name
– individual keyfob name (up to 16 characters). You can enter a name that identifies
the keyfob user.
S/N
– serial number of the keyfob.
Keyfob buttons
– for each button (combination of buttons), you can enter the number of
output to be controlled by the button (combination of buttons).
LED
– you can enter 3 digits which correspond to the input numbers (from a range of 1 to 4).
The state of these inputs will be presented by a few seconds on the keyfob LEDs after any
button is pressed. You can thus get information about the system state.
Template
– if this option is enabled, the keyfob settings are copied for each new keyfob
registered to the controller. This reduces the time required for configuration of the new
keyfobs.
Buttons
click to add new keyfob (see “Adding a keyfob” p. 53).
click to remove selected keyfob (see “Removing a keyfob” p. 53).
5.6.1 Keyfob state
Fig. 17. ABAX 2 Soft Program: “Keyfob state” tab.
Name
– individual keyfob name.
S/N
– serial number of the keyfob.
Batt.
– information about battery status:
[green] – battery OK,
[yellow] – low battery,
[gray] – low battery memory.
RSSI
– level of the radio signal received from the keyfob by the controller.
Batt.volt.
– value of the battery voltage.
Version
– keyfob firmware version and build date. The orange font indicates that a new
firmware version is available (see “Updating the firmware of ABAX 2 wireless devices”
