18 ACU-120
SATEL
AVD-100
– for the magnetic contact, enter the digit 0 (bottom reed switch) or 1 (side reed
switch) to determine which of the two reed switches is to be active. For the vibration
detector, enter 2 digits:
1
st
digit – sensitivity: from 1 to 8 (1 – minimum ; 8 – maximum).
2
nd
digit – number of pulses: from 0 to 7. For the value 0, pulses are not counted.
ASP-100
– enter 2 digits:
1
st
digit – type of acoustic signaling: from 1 to 4.
2
nd
digit – maximum duration of signaling: 1 (1 minute), 2 (3 minutes), 3 (6 minutes) or 4 (9
minutes).
ASP-105
– enter 2 digits:
1
st
digit – type of acoustic signaling: from 1 to 4.
2
nd
digit – maximum duration of acoustic signaling: 1 (1 minute), 2 (3 minutes), 3 (6
minutes) or 4 (9 minutes).
ASP-205
– for both positions taken on the list by the siren, enter 3 digits:
1
st
digit – maximum duration of signaling: 1 (1 minute), 2 (3 minutes), 3 (6 minutes) or 4
(9 minutes).
2
nd
digit – type of acoustic signaling: 0 (disabled), 1 (sound type 1), 2 (sound type 2) or 3
(sound type 3).
3
rd
digit – optical signaling: 0 (disabled) or 1 (enabled).
ASW-100 E
/
ASW-100 F
– enter 0 (only remote control of the electric circuit); 1 (remote or
manual control of the electric circuit) or 2 (remote or manual control of the electric circuit,
but with option to manually block the remote control).
LCD keypad
You can configure the wireless devices in service mode, using the following functions: U
SE
ARU-100, A
CTIVE MODE
, C
ONFIGURATION
and F
ILTER
(
S
TRUCTURE
H
ARDWARE
E
XPANDERS
S
ETTINGS
[controller name]
). Having started the function, use the
and
keys to select
the zone to which the wireless device is assigned and press the key.
Use ARU-100
Using the
and
keys select whether the wireless device is to communicate to the
controller directly, or via a selected repeater (the name of the zone to which the repeater is
assigned is displayed on the list).
Configuration
Use the arrow keys for programming additional parameters and options. The values which
can be programmed for individual parameters of wireless devices are presented in the
section describing configuration of the devices by means of the DLOADX
program.
7.3.3 Programming in the VERSA / VERSA Plus / VERSA IP system
DLOADX program
You can configure wireless devices in the “Versa – Structure” window, “Hardware” tab, after
clicking on the controller name in the list of devices. Proceed in the same way as when
programming in the INTEGRA / INTEGRA Plus system. Before making any changes, click on
the “Read” button, and after making the changes – on the “Write” button (the data relating to
the wireless devices are not read after clicking on the
button or saved after clicking on
the
button in the DLOADX program main menu).