Satcube Ku User Manual v2.0-2019
SATCUBE PROPRIETARY
d)
Recommended Configuration
For the terminal to work as intended and to provide optimal user-experience the following
configuration should be made.
•
Set embedded modem to 192.168.222.222
-
Crucial to all terminal to modem communication. Services like OpenAMIP and SNMP will
be able to send over configuration data and link information such as C/N values.
•
Enable DHCP in modem, activate automatic IP acquisition in terminal.
-
Done to allow the user to browse the web GUI from the IP shown on terminal display.
-
Allows the terminal to connect to Satcube web service which enables terminal software
upgrades, connectivity confirmation, enhanced customer support and troubleshooting.
-
Simplifies the configuration process.
e)
Initiate Factory Reset
A factory reset of the terminal from a powered off state by turning on the terminal by clicking the red
C. Directly after clicking the red C hold down the left arrow button. Keep holding down the button
until the terminal has restarted.
f)
Cloud Check
Cloud check is a feature where the terminal tries to connect to a Satcube server to verify the satellite
link
’s internet connection.
This info is then passed down to the user on the display as a pop up. It also
changes the globe icon on the display in order to indicate the terminal is connected to internet.
During the connection to the server information if a new software version is available to the user as
seen in Figure 17.
Terminal has Cloud Check enabled by default and only works if the Satcube terminal has been given
an internet enabled IP address from the modem.
g)
Diagnostic Data
At first start-up the terminal will ask the user if it agrees to share diagnostics data about the unit to
Satcube. If the user agrees the terminal will when an internet connection is established send over
anonymized data that only is used to improve the product and not used to track the user. For the
best user experience this is recommended to be switched on. It will not impact system performance.
Terminal Alignment and Transmission
The Satcube Ku display has an intuitive guide to ensure the terminal is aligned correctly and
maximum signal strength (C/N) is obtained.
Summary of Contents for Ku
Page 1: ...Satcube Ku User Manual ...
