SATA SATAjet X 5500, Operating Instructions Manual

Page: 477 / 498

477
US
Operating Instructions SATAjet X 5500 RP/HVLP (DIGITAL) Operating Instructions SATAjet X 5500 RP/HVLP (DIGITAL)
9.4. Replacing the Sealing (air side)
Danger!
• Disconnect the spray gun from the compressed air circuit!
Steps: [8-1], [8-2], [9-1], [9-2], [9-3], [9-4] and [9-5]
Replacing the self-tensioning sealing
[9-5]
is required when air leaks from
under the trigger.
1. After disassembly, please check air piston rod [9-4] and clean it, if
required. If damaged (e.g. if scratched or bent), replace it and grease
with SATA high performance spray gun grease
(Art. No. 48173)
and
insert. Please observe correct order of installation!
2. Also grease air micrometer shell, insert with air piston and tighten locking
screw using original SATA combination tool with max. 1 Nm.
After installation, please adjust material flow according to chapter 7.2.
Danger!
• Check if the locking screw has been firmly tightened! The air microm -
eter could shoot out from the spray gun uncontrolled!
9.5. Replace CCS (ColorCode-System)
The CCS for the individual marking of the spray gun can be exchanged
according to
[9-6]
.
9.6. Replace spindle of round/flat fan control
steps:
[10-1], [10-2], [10-3]
The spindle has to be replaced when air leaks from the fan control or
when the fan control does not work.
1. Removing the old spindle
• Remove screw [10-1] (Torx T20)
• Remove control knob [10-2]
• Unscrew spindle [10-3] with wrench (size 14)
• Make sure that the spindle pick-up is free of material and paint resi-
dues, remove residues and clean with solvent, if necessary
2. Installation and position of new spindle
• Screw in spindle [10-3]
• Place the knob [10-2] on hexagonal of spindle