![background image](http://html1.mh-extra.com/html/sata/lps-r-2000/lps-r-2000_operating-instructions-manual_1200084042.webp)
42
EN
Operating Instructions SATA LPS R 2000, SATA LPS RB 2000 RP, SATAminijet 1000 A S HVLP
spanner
[3-5]
.
■
Only for SATA LPS RB 2000 RP:
Remove spacer
[11-2]
.
■
Mount the spindle
■
Only for SATA LPS RB 2000 RP:
Place the spacer
[11-2]
over the
spindle holder
[11-1]
.
■
Screw spindle
[11-3]
into the gun body using the SATA universal span-
ner
[3-5]
.
■
Position the control knob
[11-4]
.
■
Coat the countersunk screw
[11-5]
with Loctite 242 and screw hand-
tight.
9.5. Replace sleeve
Attention!
Air leaks from the material flow control inspection hole
If the sleeve is damaged, air can leak from the material flow control in
-
spection hole
[1-2], [2-6]
.
→ Replace the sleeve immediately.
The sealing surface of the sleeve is very sensitive and damages easily.
→ Do not chuck the sleeve on the sealing surface.
Remove sleeve
■ Unscrew the material flow control [9-1].
■
Remove the spring [9-2].
■
Remove the paint needle [9-3].
■ Loosen the SW14 hex nut [12-1], holding the second SW14 hex nut
[12-4]
in place.
■ Remove hex nut, flat washer
[12-2]
and sleeve
[12-3]
.
Mount sleeve
Note!
Do not damage the sealing lip of the sleeve when mounting!
■
Push the sleeve
[12-3]
, flat washer
[12-2]
, and SW14 hex nut
[12-1]
onto the paint needle
[12-5]
.
■ Tighten the SW14 hex nut, holding the second SW14 hex nut
[12-4]
in
place.
■
Insert the paint needle
[9-3]
.
■
Insert the spring
[9-2]
.
Summary of Contents for LPS R 2000
