![background image](http://html1.mh-extra.com/html/sata/95107a/95107a_user-manual_1200079008.webp)
中文
EN
DE RU KO PT
JA
ES
95107A
8
Introduction:
Initial use:
Factory settings: user's initial password "1111" and administrator's initial password "00000000".
1
)
Enter your newly set password
(
4 - 10 digits
)
or the initial password
(
if you did not make a change
)
, and press "
←
" key to
unlock.
2
)
If the password is correct, the green indicator will come on; if it is incorrect, the yellow indicator will flash.
3
)
When the green indicator is on, please pull the door outward to open it.
Unlock: After entering the correct password, press "
←
" key, the green indicator will come on, the latch will retract, and the cabinet will
be accessible.
Setting password:
Both of the initial passwords are used to open the door for the first time. For maximum safety, be sure to change them immediately. The
methods for changing both of them are as follows:
1. Changing user's password
User's password is made up of 4 ~ 10-digits. The password will be saved for a long time after power off. The user's
password can be changed by the user.
Changing method: Press the "
←
" key twice within a short time. The yellow indicator flashes.
→
Enter the old password.
→
Press "
←
" key to confirm the input.
→
Enter the new password.
→
Press "
←
" key to confirm the input. The green indicator
will stay on. Two beeps indicate the new password has been set successfully.
2. Changing administrator's password
Administrator's password is made up of 6~ 10-digits. The password will be saved for a long time after power off. The administrator's
password can be changed by the administrator.
Changing method: Press and hold the "
←
" key for 5s. The yellow indicator flashes.
→
Enter the old administrator's password.
→
Press "
←
" key to confirm the input.
→
Enter the new administrator's password.
→
Press "
←
" key to confirm the input. The green
indicator will stay on. Two beeps indicate the new administrator's password has been set successfully.
3. Encryption protection
The yellow indicator will flash four times and at the same time four beeps will be heard if an incorrect password is entered. If an
incorrect password is tried three times, the system will automatically be locked for 1min and no response will be given by operating
the keypad to avoid password snatching.
4. Low-voltage alarm
When the voltage is too low, the red indicator will flash and 4 groups of beeps will be heard after unlocking using passwords. After
this first alarm, unlocking will be enabled for about 200 times. Please replace the battery as soon as possible.