16
51075C
OPERATION INSTRUCTIONS
Before use
1) Charging
The charger shall be used with the machine tool.
Using other chargers is not allowed.
The machine tool is equipped with a protective
circuit. When the battery level is low, the
protective circuit will open and the machine tool
will stop rotating.
The machine tool may heat up in higher
temperature environments or after long use.
In this case, please do not immediately charge
it until it has cooled down, or else the service
life of the battery will be shortened or it will
not be possible to charge the battery due to
overheating.
When the machine tool is charged for the first
time or is not used for a long time, the efficiency
of the charger may only reach about 60%, and
should reach 100% again after 2–3 instances of
charging and discharging.
2) Installation/removal of battery pack (see
Figure A)
To remove the battery pack, press down the lock
button in front of the battery pack and pull it
out. To insert the battery pack, just push it into
the machine tool. Do not apply excessive force.
OPERATION
1. Start/stop (see Figure B)
Press and hold switch (1) to start the machine
tool, then release it to stop the machine tool.
2. Speed regulation with switch
Force applied to the switch can change the
Attention: Please read these
instructions carefully before use.
Please keep these instructions for
future reference.
2
C
1
B
D
A
E
Summary of Contents for 51075C
