SATA 51005, User Manual

Page: 14 / 68

中文
EN DE RU KO PT JA ES 51005
14
Wood 20mm
Machine weight 1kg
Battery capacity 2000mA
Recharge time 45min
Operation guideline
Caution:
Please read the instruction carefully before operating the machine.
Before the use:
1
）
Charging
This charger and machine shall be used together. Do not use other chargers.
The machine has a protection circuit. When the battery is low, the protection circuit is turned on and the machine stops rotating.
The machine may become hot under the high temperatures or after a long period of operation. At this time, do not charge
immediately but wait until the battery is cooled. Otherwise, the service life of battery will be shortened or the charging failure may
be caused due to overheating.
For the first charging or after a long period of storage, the efficiency of first charging may only reach about 60%. After 2-3 charging
and discharging cycles, the battery efficiency may reach 100%.
2
）
Installation and removal of battery pack
（
see Figure A
）
Press the lock buttons on both sides of battery pack and pull it out. To insert the battery pack, simply push it into the machine. Avoid
the excessive force
Operation
1. Start/stop
（
see Figure B
）
:
Press and hold the switch
（
1
）
to start the machine, and release it to stop the machine. The switch has the brake function. When the
switch is released, the chuck stops rotating immediately.Change the force applied to the switch to regulate the rotating speed. The range
of adjustment is between 0 and the maximum rotating speed. The smaller the force is, the lower the rotating speed is. The drilling starts
slowly and stably Prevent the shutdown of machine due to the excessive load.
Warning:
Do not operate at low speed for a long time. Otherwise the machine will be overheating inside
2. Switch lock
（
see Figure B
）
:
The switch has the lock protection function which helps to avoid the accidental activation of the hand drill. Lock the machine by
adjusting the reversing yoke
（
2
）
to the center position.
3. Rotation reversing
（
see Figure B
）
:
Forward: Push the side of reversing yoke marked with "
←
" to the end
（
left side
）
for drilling and screwing the screw. Reverse: Push the
side of reversing yoke marked with "
→
" to the end
（
right side
）
for releasing or unscrewing the screw.
Warning:
The rotating speed can only be changed after the machine is completely still.