Sartorius Biowelder Total Containment, Operating Manual

Page: 34 / 232

34 Operating Manual Biowelder
®
Total Containment
Sequences
7.2.2 Abort in the critical section
Basically, there are two ways to abort the welding process in the critical
section. If the operator control shows the “Power has failed” message, a
network interruption has discontinued the welding process in the critical
section. If the operator control
shows the “Failed in critical section” message, the welding process was
aborted in the critical section because of a drive blockage.
Sartorius Stedim Biotech recommends that a rewelding be selected to
minimize the risk of failure . When in the critical section while using liquid
filled tubing welding, select “Reweld” only to avoid liquid on the device .
Follow the operating instructions. Proceed according to the following diagram:
Acknowledge the message
“Power failure!
Read manual”
Reversing from
critical section
Remove blade
Check tubes sealing and close
cover to reverse
Reweld Reverse
Device is executing
a reweld
Remove blade
Reversing from non-critical
section
End
Remove tubes carefully
Correct tube
type chosen?
Adjust tube type.
See chapter “Operation”
No
Yes
Start after
Failed in critical section
Reversing from
critical section
Acknowledge the message
“Failed in critical section!
Read manual”
Choose option
“Reweld” or
“Reverse”
Start after power fail
Remove blade
(only after power fail)
Insert blade and close cover.
Press start button
Remove blade
The blade is brought to the starting position with „Device reverted from
the critical section“ . Both welding axes remain closed so that fluid can not
flow out .
Clamp the tubes very close to the housing but outside the cover . This
minimizes damage in case of failure .