Sanyo WXU700 - WXGA LCD Projector, Owner'S Manual

Page: 139 / 154

1
4. Type the commands, refer to below table, to control the projector and then press "Enter" key for
termination. For example, type "C00" which is a command to turn on the projector, and press "Enter"
key. Confirm the projector is turning on.
*
Enter with ASCII 64-byte capital characters and one-byte characters.
To disconnect the communication, press "Ctrl" key and "]" key at the same time, type "close" and then
press "Enter" key on the Keyboard.
> close [return]
The table below shows the typical command lists for controlling this projector and please consult your
local dealer for further information of another commands.
*1 Further instructions about the telnet application, please see the on-line guide on your computer.
*2 The password is a Network PIN code decided item "Network PIN code setting" (
+ p.32, 42). If the authentication of
the entered password is failed 4 times continuously, the communication will be disconnected automatically. Please
try again for the connection.
*3 If the password or any command is not entered for more than 30 seconds, the communication will be disconnected
automatically. Please try again for the connection.
Command Function
C00 Power on
C02 Power off
C09 Volume up
C0A Volume down
C0B Audio Mute on
C0C Audio Mute off
C1C Menu display on
C1D menu display off
Command list table
Use of telnet