Sanyo SHP-C90GDN, Technical Manual

Page: 23 / 76

− 23 −
Errors messages from the heat pump: (H01
㧙
H27)
If an error occurs,cut off Power supply once, and please run again. But if an error
occurs again, please call service. (Write the error message down.)
Status messages:
Status messages are shown in the normal display window.
WITHOUT HP
: the tank is operated without heat pump. The heat pump is not
chosen in me
QX´VHWWLQJV´
CURRENT REDUCED: when the main fuses are protected by reducing the
power in the boiler this message is shown.
POWERS REDUCE: after a voltage interruption (or when starting the tank unit), the
electrical immersion heaters are reduced to maximum 6 kW load for approximately 2
hours. This helps to keep the load on power supply net down.
SUMMER LIMIT: the heat to the radiators is automatically stopped during
summer. The circulating pump stops. You can choose summer limit
temperature in
PHQX´VHWWLQJV´
11. More useful information
The room sensor
You can choos
H´12´
in menu settings
DW´52206(1625´LIWKHURRP
sensor is difficult to install, place, if there are more than one apartment, if
there is a floor heating system with separate room sensors or if you often
heat in an open fire place. The alarm diode is still functioning when alarms
occur.
If you heat in an open fire place or oven, the temperature can affect the
room sensor. It may be cold in other parts in the house. You can then
temporarily operate the system without room sensor during the time you
fire. The system operates towards the outside temperature (heat curve).
The thermostatic radiator valves will reduce the temperature where you
fire.
Out door temp sensor error
The system simulates -5°C outside temperature if the sensor doesn
¶W
work. An alarm will appear.
My settings
Use this table to write down your own settings. Use a pencil so that you
can erase and write down new settings.
Head fuse(A) Delay el heater
(H min)
El heat temp up
(
͠
)
El heat temp low
(
͠
)
Max kW heat up
(
͠
)
Max kW heat low
(
͠
)
Summer limit (
͠
)
5
oom sensor
(Yes/
1
o)
Max out (
͠
) Min out (
͠
)
Curve incl (
͠
) Curve adjust (
͠
)
1LJKWWHPS
(Yes/
1
o)
Adjust (
͠
)