Sanyo PLC-XU101, Service Manual

Page: 7 / 108

-7-
Turn off the projector, and unplug the AC power cord
from the AC outlet.
Turn the projector over and remove the filter by pulling
the latches upward.
1
2
Filter prevents dust from accumulating on the optical elements inside the projector. Should the filter becomes
clogged with dust particles, it will reduce cooling fans’ effectiveness and may result in internal heat buildup and
adversely affect the life of the projector. If a “Filter warning” icon appears on the screen, clean the filter immediately.
Clean the filter by following the steps below.
Gently clean the filter by using a brush or rinse it softly.
3
When rinsing the filter, dry it well. Replace the filter prop-
erly. Make sure that the filter is fully inserted to the pro-
jector.
4
cAutIoN
Do not operate the projector with the filter removed.
Dust may accumulate on the optical elements de-
grading picture quality.
Do not put anything into the air vents. Doing so may
result in malfunction of the projector.
recoMMeNdAtIoN
We recommend avoiding dusty/smoky environments when
you operate the projector. usage in these environments may
cause poor image quality.
When using the projector under dusty or smoky conditions, dust
may accumulate on a lens, LCD panels, or optical elements in-
side the projector degrading the quality of a projected image.
When the symptoms above are noticed, contact your authorized
dealer or service station for proper cleaning.
✔
Note :
• When reinserting this filter, be sure that the slit
part is facing the outer side.
Filter
Pull up and remove.
Be sure to reset the Filter counter after cleaning or replacing the filter.
Press the MENU button to display the On-Screen Menu.
Use the Point
7 8
buttons to move the red frame pointer
to the Setting Menu icon.
Use the Point
ed
buttons to move the red frame pointer
to Filter counter and then press the SELECT button. A
dialog box appears showing the total accumulated time
of the filter use, a timer setting option, and the reset op-
tion. Select Reset and the “Filter counter Reset?” ap-
pears. Select [Yes] to continue.
1
2
Resetting the Filter Counter
Filter counter
Select Reset and the “Filter
counter Reset?” appears.
Select [Yes],
then another
confirmation
box appears.
Another confirmation dialog box appears, select [Yes] to
reset the Filter counter.
3
Cleaning the Filter
Maintenance