Sanyo PLC-XC56, Owner'S Manual

Page: 115 / 174

33
ENGLISH
About projector condition
Status Description
Normal ............................................................... Projector is operating normally.
Power management in operation ........... Power management is operating
Lamp failure ................................................... Lamp failure is occurring
Abnormal Temperature ......................... The temperature of the projector became too high
Standby after Abnormal Temp. ........ Projector detects abnormal temp. and sets into standby mode.
Power failure ................................................ Power failure has occurred inside the projector. Projector is turned
off. Unplug the AC cord and ask servicing to a qualified service
personnel.
Service in need ............................................ Projector detects maintenance requirement. Check up LED status
of the projector.
Power control and status check
When a security (PIN code lock) has been set on the projector, you also cannot
control it through the network. To control the projector through the network,
unlock the security on the projector using with the projector's menu control.
Caution about turning on/off the projector via the networks
When turning on/off the projector via the networks, preset the projector as fol-
lows:
1. Select “Setting” from the Projector menu.
2. Select “Standby mode” from the Setting menu and set it as “Network”.
If you set this function as Network, the network part of the projector is con-
stantly provided with power even if the projector is turned off. If you set this as
Eco, then the network part will be turned off when you turn off the projector.
Consequently, you cannot turn on/off the projector via the networks.