Sanyo PLC-HP7000L, Service Manual

Page: 11 / 168

-11-
Maintenance
Turn off the projector and unplug the AC power cord.
Let the projector to cool for at least 45 minutes.
Loosen the screw and open the lamp cover and pull
out the lamp by using the built in handle.
1
3
Replace the lamp with a new one. Make sure that
the lamp is properly and fully inserted.
4
Open the filter cover.
2
Connect the AC power cord to the projector and turn
on the projector.
6
Follow these steps to replace the lamp.
reset the lamp replacement counter
5
Note:
• Be sure to insert the lamp in the correct direction.
• Do not reset the Lamp replacement counter when the pro-
jection lamp is not replaced.
Lamp Replacement
For continued safety, replace with a lamp of the
same type. Do not drop the lamp or touch the glass
bulb! The glass can shatter and may cause injury.
Allow a projector to cool for at least 45 minutes
before you open the lamp cover. The inside of the
projector can become very hot.
CAUTION
CAUTION
When the projection lamp of the projector reaches its end of life, the lamp replacement icon appears on the screen
and LAMP REPLACE indicator lights orange. Replace the lamp with a new one promptly. The timing when the LAMP
REPLACE indicator should light is depending on the lamp mode.
Top Panel
LAMP REPLACE indicator
Lamp replacement icon
7
Close the lamp cover and secure the screw, and
close the filter cover.
Lamp
Handle
Lamp cover
Filter cover
Screw
order rePLAceMeNt LAMP
type No. PoA-LMP149
Service Parts No. 610 357 0464