Sanyo HVR-DX610, Instruction Manual

Page: 16 / 66

INTRODUCTION
15 14
!
AC Power Cord
Plug into a power outlet.
@
AUDIO OUT (L, R)
Connect to a TV or other equipment with audio
inputs.
#
COMPONENT/PROGRESSIVE VIDEO OUT (Y Pb Pr)
Connect to a TV with Component Video (Y Pb Pr)
inputs.
$
AV OUT JACK
Connection of a TV set. Composite video output
and audio output (L, R).
%
AV IN JACK
Connection of an additional device's
video_output and audio_output.
^
RF IN (FROM ANT.)
Connect to your antenna or cable TV outlet.
&
RF OUT (TO TV)
Connect to a TV with an RF coaxial input.
*
COAXIAL (Digital Audio Out)
Connect to an amplifier with a coaxial digital
audio input.
(
S-VIDEO OUT
Connect to a TV with an S-Video Input.
Rear panel
Caution
• Do not touch the inner pins of the jacks on the rear panel. Electrostatic discharge may cause permanent damage
to the DVD RVCR.
! @# $% ^
( * &
Identification of Controls
Connections
Connections
Connecting Antenna/Cable
1
Disconnect the antenna/cable from the rear of your
TV.
2
Connect this cable to the jack marked RF IN (FROM
ANT.) on the rear panel of the DVD RVCR.
If your cable wire is connected to your TV without a
converter or descrambler box, unscrew the wire from your TV and attach it to the RF IN (FROM ANT.) jack on the
rear panel of the DVD RVCR.
Use the supplied RF cable to connect between the DVD RVCR’s OUT (TO TV) jack and the antenna input
jack on your TV. With this connection, you can receive all midband, superband, and hyperband channels (all
cable channels).
• There are a variety of ways to connect the DVD RVCR to your TV and other equipment. Use only one of
the connections described below. Whichever TV connection you use will work with all input sources.
• Please refer to the manuals for your TV, VCR, stereo system, or other devices as necessary to make the best
connections.
• For better sound reproduction, connect the DVD RVCR’s AUDIO OUT jacks to the audio in jacks of your
amplifier, receiver, stereo, or audio/video equipment. See ‘Connecting an Amplifier/Receiver‘ on page 17.
Caution
• Make sure the DVD RVCR is connected directly to the TV, and the TV is set to the correct video input.
• Do not connect the DVD RVCR’s AUDIO OUT jack to the phono in jack (record deck) of your audio system.
• Do not connect the DVD RVCR via your VCR. The DVD image could be distorted by the copy protection
system.
CONNECTIONS
Antenna Antenna
Cable TV
Wall Jack
Flat Wire
(300ohm)
300/75ohm Adapter
(Not supplied)
or or
Rear of DVD RVCR