23
INSTALLING YOUR DVD RECORDER
INSTALLATION MENU
Initial Setup
After exiting standby the system turns on FreeView mode. Since this is
the first time that the receiver has been used, there are no channels
stored in the receiver and the Auto search selection menu is displayed on
the screen. If you do not see the APS (Automatic Programme Search)
search menu on the television screen after a few minutes, refer to the
Troubleshooting.
Using the
3
/
4
keys on the remote control, make sure that the
YES button is highlighted in yellow, and press the SELECT key to
start the automatic search. The FreeView receiver will
automatically tune to the UHF transmission channels 21 to 68
looking for digital terrestrial TV broadcasts and displaying the
names of channels found. This process may take about a few
minutes.
If no digital terrestrial television broadcasts are found, the receiver
will display a warning message. Check that an aerial is connected
to the aerial input socket of the recorder.
NOTE
: Important that you must NOT turn off the recorder within 5 seconds after the automatic search since
the unit is updating the program table and all channels may be lost.
Automatic program search for Analogue channels
Use
5
/
6
keys to select the date box and press SELECT to edit date. You can come to the place that you
will change by using
3
/
4
keys and make the changes by using number keys and
5
/
6
keys.
