14
1
Install batteries in remote control (2AA, not included).
2
Connect Signal to the DTV’s Integrated Analog / Digital
75 ohm Antenna Input terminal.
GETTING STARTED (REQUIRED INITIAL SETUP)
PRECAUTIONS
To ensure safe operation, please observe the following
precautions:
Replace both batteries at the same time. Do not use a new
battery with a used battery.
Risk of explosion, if battery is replaced by an incorrect
type.
Do not expose the Remote Control Unit to moisture or
heat.
RF ANTENNA
CABLE
OR
CABLE BOX OR SATELLITE BOX
OR
ANALOG / DIGITAL
ANTENNA IN
THE TUNER IN THIS DTV CAN RECEIVE:
1. Digital and / or Analog Off-Air Signals from an RF
antenna.
OR
2. Analog or ClearQAM cable channels.
Note:You must search for ClearQAM channels using
the “Digital Cable Search” menu option.
OR
3. The output from a VCR or cable box.
Digital signals from a Set-top (STB) Box should be
received through the Component jacks.
This DTV can receive ANY unscrambled RF signal
being broadcast.
(CONTINUED ON NEXT PAGE.)
Match the “+” and “–”
signs on the batteries with
marks inside the remote
control.
DTV RIGHT SIDE (VIEWED FROM BACK)