1
1
- 8
A:
When the unit is in the heating standby mode, the
indicator appears. (Refer to the description of the
Special Remarks on page 12.)
B:
The currently selected operation mode is displayed.
C:
This is displayed when a different operation mode was already selected by another remote control unit and
indicates that the mode cannot be changed.
D:
When the TIMER SET button is pressed to set the timer, the
indicator flashes.
E:
The currently selected FAN SPEED is displayed.
F:
The currently selected Airflow Direction and SWEEP status are displayed.
G:
This is displayed only when an abnormality occurs within a unit.
H:
When the CHECK button is pressed, the TEST indicator appears.
I:
This is displayed to indicate that the system controller is being used for control.
When
is flashing on the display, the operation is not accepted by the system controller.
J:
This indicates the indoor unit address in case of group control.
Unit No.
1 — 2
Indoor unit No.
Refrigerant circuit No.
K:
This is displayed when it is time to clean the filter.
L:
When setting the timer, the selected timer mode is displayed.
M:
This indication appears when the temperature is set.
N:
This indication appears when the remote control sensor is used.
O:
This indication appears when the ventilation fan does not operate even if the ventilation button has been
pressed.
P:
This indication appears when the ventilation fan is operating.
Description
B
D
G
A
H
Display (Remote Control Unit)
When you first turn on the ON/OFF operation button,
will blink on the display of the remote
controller. During this blinking, the remote controller is verifying units connected. Use the remote
controller, after stops blinking.
C
E
F
I
J
M
P
N
O
K
L
06-212 PAC-i_IM_Sec1 4/12/06 7:15 PM Page 8
