2
2
- 11
O: SENSOR button
Use this button to switch to the temperature sensor of the remote
controller.
The temperature sensor of the air-conditioner is selected at the factory
and the display indicates
under this selection.
If the remote controller is located near a heat source, such as a space
heater or in direct sunlight, press the SENSOR button to switch to the
sensor on the indoor unit.
P: ACL button
Puts the wireless remote controller into pre-operation status. Always
(ALL CLEAR)
press this button after replacing the batteries.
Q: DISPLAY
Information on the operating conditions is displayed while the wireless
remote controller is switched on. If the unit is turned off, only the mode
that was set previously is still displayed.
Remote Control Unit (continued)
NOTE
NOTE
• The wireless remote controller sends the temperature signal to the air conditioner regularly at three
minute intervals. If the signal from the wireless remote controller stops for more than ten minutes
due to the loss of the wireless remote controller or other trouble, the air conditioner will switch to the
temperature sensor which is built into the indoor unit and control the room temperature. In these
cases, the temperature around the wireless remote controller may differ from the temperature
detected at the air conditioner’s position.
NOTE
DIP
s
witch
s
ettin
gs
when the wirele
ss
remote controller will
b
e u
s
ed for coolin
g
only
•
If
the
wireless
remote
controller
will
b
e
used
for
cooling
only,
refer
to
the
figure
b
elow
and
mo
v
e
the
switch
to
position
C.
S: Flap type with limit switch
(4-way, ceiling-mounted, wall-mounted)
K: Swing-only type (floor-mounted) installed
N: No-flap type (built-in)
Check that sliding switch 1 is set to “S.”
Set sliding switch 2 to match
the unit type.
A: Heat-pump type
(H: Heat pump with
no auto heat/cool)
C: Cool-only type
Sliding switch 1
SKN
AHC
AHC
ACL (ALL CLEAR)
button
Sensor button
Sliding switch 2
NOTE
05-368 PAC-i_IM_Sec2 12/7/05 4:36 PM Page 11
