SANY SY16C, Operation And Maintenance Manual, Page: 151 / 208

SY16C Excavator OMM Maintenance
SANY
Operation and Maintenance Manual — 0420
5-19
TABL
E OF
CONT
E
N
TS
INTRODUCTION
SAFE
T
Y
MACHIN
E
CONTROLS
MACHINE
OP
ERA
T
IO
N
MA
INTENANCE
SPEC
IFI
CA
TIO
N
S
OP
T
IO
N
A
L
EQUI
PMENT
Prestart Inspection
For more information, see “Daily Inspection and Maintenance” on page 5-11.
Check the Engine Oil Level
See “Engine Oil Level Check” on page 4-8.
Change the Engine Oil and Filter
1. Prepare the machine for service. See “Maintenance Safety” on page 2-9.
NOTE: For engine oil capacity, see “Fluid Capacities” on page 5-9.
2. Place a suitable container under the drain plug (1).
3. Remove the drain plug and allow the oil to drain.
4. Install the drain plug.
Pre-start Check
Reference
Check the engine coolant level and top off as
necessary.
“Engine Coolant Level Check” on page 4-7
Check the engine oil level. “Engine Oil Level Check” on page 4-8
Check the fuel level and add as necessary. “Fuel Level Check” on page 4-9
Drain water from the fuel/water separator. “Drain the Fuel/Water Separator” on page 4-10
Check hydraulic oil level and add as necessary. “Hydraulic Oil Level Check” on page 4-11
Check the electrical wires and connectors for damage. “Electrical Components Check” on page 4-13
Check the horn operation. “Horn Function Check” on page 4-13
NOTICE!
Dispose of used oil and filter in accordance with all applicable environmental regulations.
Failure to do so could damage the environment.
Fig. 5-3 0003218
1