SANY SY16C, Operation And Maintenance Manual, Page: 79 / 208

SY16C Excavator OMM Machine Operation
SANY
Operation and Maintenance Manual — 0420
4-7
TABL
E OF
CONT
E
N
TS
INTRODUCTION
SAFE
T
Y
MACHIN
E
CONTROLS
MACHINE
OP
ERA
T
IO
N
MA
INTENANCE
SPEC
IFI
CA
TIO
N
S
OP
T
IO
N
A
L
EQUI
PMENT
FLUID LEVEL CHECKS
Complete the following procedures in this section before starting the engine.
Engine Coolant Level Check
1. Park the machine for maintenance. See “Maintenance
Safety” on page 2-9.
2. Open the engine hood.
NOTE: See “Recommended Lubricants, Fuels, and
Coolant” on page 5-8.
3. Make sure the engine coolant level in the overflow
tank (1) is between the FULL (2) and LOW (3) marks.
If the engine coolant level is low, add engine coolant
through the fill opening (4) of the overflow tank until
the engine coolant is at the FULL mark.
4. Install the fill cap after refilling.
WARNING!
• Engine coolant is toxic. Avoid inhaling or ingesting engine coolant. If eyes or skin are
contaminated by coolant, wash the affected area with plenty of water and seek medical
treatment immediately.
• Engine coolant may be under pressure when the engine is hot. Avoid contact with hot
engine coolant. Allow the engine to cool before removing the radiator cap.
Failure to follow these warnings could result in death or serious injury.
NOTICE!
• If the overflow tank is empty, there may be an
engine coolant leak.
• Inspect for engine coolant leaks and repair if
found. If a leak is not found, check for an
internal leak.
Contact a SANY dealer for additional
information.
Fig. 4-1
0005082
1
3
2
4