SANY SY16C, Operation And Maintenance Manual, Page: 81 / 208

SY16C Excavator OMM Machine Operation
SANY
Operation and Maintenance Manual — 0420
4-9
TABL
E OF
CONT
E
N
TS
INTRODUCTION
SAFE
T
Y
MACHIN
E
CONTROLS
MACHINE
OP
ERA
T
IO
N
MA
INTENANCE
SPEC
IFI
CA
TIO
N
S
OP
T
IO
N
A
L
EQUI
PMENT
6. The engine oil filler cap (4) is behind the coolant over
flow tank. Add engine oil as needed. Always use
SANY-recommended engine oil.
NOTE: If the engine oil level is above the upper mark
on the dipstick, drain the excess engine oil.
See “Change the Engine Oil and Filter” on
page 5-19.
Fuel Level Check
1. Turn the key switch to ON to activate the monitor.
2. Check the fuel level on the monitor. See “Engine Service Hour/Engine Fuel Level” on page 3-21.
3. Turn the key switch to OFF.
Add Fuel
1. Remove the fuel tank filler cover. See “Fuel Tank Filler Cover” on page 4-10.
2. Fill the machine with clean diesel fuel as necessary.
NOTE: Never overfill the fuel tank. Stop fueling if the fuel spills over the fuel fill strainer. Make sure the fuel
gun nozzle does not damage the fuel fill strainer.
3. Install the fuel tank filler cover after refueling.
WARNING!
• Fuel or fuel vapors that come into contact with hot surfaces or electrical components can
cause a fire.
• Never service the fuel system near an open flame or while smoking.
• Clean up spilled fuel immediately.
Failure to follow these warnings could result in death or serious injury.
NOTICE!
Contaminated fuel can cause engine damage or improper machine operation. Fill the fuel tank
with clean diesel fuel.
Fig. 4-4
0005166
4