Sanwa MT-5, User Manual

Page: 61 / 78

50
How to Use Each Feature
ENTER
Flashing
Note that, in SHR/SSR/SUR mode, an analog servo will not work. If you mistakenly use an analog servo in
SHR/SSR/SUR mode, it will not operate normally and the servo will be broken.
Do not use an analog servo in SHR/SSR/SUR mode.
For digital servo (SRG, ERB ERS series, Digital ERG series), it can work for either mode of NOR/SHR.
SSR mode works only for PGS ,SRG servo, SUPER VORTEX series, HV-12 STOCK SPECIAL and HV-01.
SUR mode works for only PGS servo, SUPER VORTEX Gen2 / PRO / SV-D2.
In SHR/SSR mode, BL/RACER, BL/FORCE, F2000, F2200, F3000, F3300, SBL-01, 02 and 03CL do not work.
BL-SIGMA, SV-08, HV-10, HV-12 and F2500 work in NOR/SHR mode.
•
•
•
•
IMPORTANT
Note
• BINDING is not done at the factory. Please make sure to complete BINDING before use.
• When the receiver is new, make sure to complete BINDING for the transmitter and the new receiver.
• Make sure to use the set of the transmitter and the receiver that completed BINDING.
•
•
When changing the setting in the BIND menu after BINDING, repeat BINDING.
When changing the setting of the mode (NOR/SHR/SSR/SUR) after BINDING, repeat BINDING. If you do not re-BIND, setting changes will
not be reflected.
Push
ENTER
⇒
・・・・・・・・・・・・・・・・・・ ・・・・・・・・・・・・・・・・・ ・・・・・
Status of the Receiver LED
(Flashing with approximately
0.5-second interval)
(High-speed flashing)
(Light goes off)
BINDING Complete
(Light on)
•
Push
Note) Though the wire is not connected
to the above-mentioned receiver,
keep the servo and FET speed
controller (excluding motor),
battery in connected state.
BIND plug
Connect BIND
plug to receiver
Switch ON
Switch ON the power
supply of receiver/
FET speed controller.
6)Setting Channel Mode
Set the response mode for each channel with Up key/Down key.
・ You can the set the response mode for each channel.
○
Setting Range: NOR(Normal)
SHR(High Response)
SSR(Super Response)
SUR (Ultra Response)
○ Default: NOR
7) Setting BIND
● What is BIND: Each of MT-5 transmitters has its own unique ID (solid identification) number. BIND is to
let the receiver memorize the ID number. Operation will be possible only between the transmitter and the
receiver that completed Binding.
1] When setting in the BIND menu is done, set BIND with the multi-
selector.
2] Move the cursor to [ENTER] in the BIND menu and operate
Enter. The transmitter now is ready for BIND operation.
3] Turn on the receiver with inserting Bind Plug in BIND/SSL port.
4] When BINDING is done properly, the LED of the receiver starts
flashing slowly at first then it flashes in high speed and the
LEDgoes off. When the LED of the receiver goes off, operate
the Enter key of the transmitter to complete BINDING of the
transmitter.When BINDING is done properly, the LED of the
receiver is lit.When the LED of the receiver is lit, activate the
servo to check if BINDING is completed.
*When BINDING cannot be done properly, restart from step 2).