6
Instruction Manual for BIO-WALL™
1-888-726-8869
www.sanuvox.com
STEP 5
STEP 11
STEP 6
STEP 7
STEP 8 & 9
STEP 10
Assemble BIO-WALL™ Supports
5. Start by measuring the height of the duct. Then cut two pieces of support
pipe this height – minus 1.5" (3.8 cm) to accommodate the mounting
flanges.
11. Having determined where the ballast box will be installed, drill a 1.125”
(2.85 cm) hole in the conduit to bring the cable through.
NOTE:
Put the supplied plastic grommet in the hole to protect the cable.
6. Insert a clamp assembly on each section and tighten it in the center with
the bolts provided for this purpose.
7. Attach the mounting flanges to each end of the pipes and tighten them in
place.
Install 2 Assembled Supports in Duct
8. Knowing the total length of your installation (see the table in step 1),
attach the pipe furthest downstream, in the center of the conduit. Screw
it in place, making sure that the clamp is in the center of the pipe, facing
you and its opening facing up.
9. Attach the 2
nd
pipe, the one closest to your access door, by distancing it
from the other according to the table in step 1. Screw it in place, making
sure that the fixing clamp is in the center of the hose, pointing towards
you and its opening facing upwards.
Install Extrusion and Lamps onto Clamps
10. Without removing the film that protects the lamps, take the extrusion by
the side of the power cable and insert everything into the duct: place the
extrusion at the bottom of the duct.
Summary of Contents for Bio-Wall MAX
Page 9: ...ELECTRICAL DIAGRAM ...
Page 10: ......
