5
Use screws to mount the inverter to a solid surface. The recommended screw size
is M4*50~65mm.
Screws locations of 3K model Screws locations of 5K model
2.4 Battery Connection
CAUTION:
For safety operation and regulation compliance, it is requested to
install a separate DC over-current protector or disconnect device between battery
and inverter. Note that some installation requirements may not require a
disconnect device, however, an over-current protection installed is still required.
Please refer to typical amperage in below table as required fuse or breaker size.
WARNING!
All wiring must be performed by a
qualified technician
WARNING!
Check the polarity before connecting the battery wires
in order not to damage the inverter.
