10
Sanli Brushcutter User Guide
Take approximately 4-5 metres of
2.0-2.4mm diameter trimmer, fold in
half to make a loop. Hold the spool as
shown in
(Figure 14)
and hook the loop
onto the divider plate as shown and
wind the line, one on either side of the
divider plate.
Wind both lines
clockwise
on both
sides of spool ensuring that both lines
remain in their respective channels see
(Figure 15).
In order to stop the line from
unravelling, slip each end into the lugs
on the bottom edge of the spool see
(Figure 16).
Insert ends of lines through holes in
side of spool casing and place the
spool into the centre of the casing see
(Figure 17)
.
When in position pull the ends further
out of the casing.
Then return the lid, click into place and
return to hub.
Replacing trimmer line - bent shaft.
Figure 14.
Figure 15.
Figure 16.
Figure 17.
