6
Sanli Brushcutter User Guide
Attaching the handle
- straight shaft.
Place the upper ergonomic handle in the
desired position, (
Figure 1)
then while
holding the lateral handle underneath in
position insert the screws and tighten with
the allen key provided.
Attaching the safety guard
- straight shaft.
While placing the brushcutter on its back
place the guard as shown in
(Figure 2)
and locate the screws through the tension
plates as indicated and tighten screws.
Figure 1.
Figure 2.
Attaching the handle
- bent shaft.
Place the upper ergonomic handle (
Figure
3)
over the sliding sleeve in the desired
position, then while holding the bottom
plate in place underneath insert the screws
and tighten with the allen key provided.
Attaching the safety guard
- bent shaft.
While placing the brushcutter on its back,
clip the guard onto the shaft lining the
holes up with the guides see
(Figure 4)
then locate the bolt through the guard and
guide plate as indicated. Place the washer
over the bolt and tighten wing nut.
Figure 3.
Figure 4.
