Sankyo CSS Series, Assembling Manual

Page: 31 / 36

31
Cutting procedure of depth direction (processing on site)
1. Cutting the beams
2. Cutting the gutters
3. Cutting the rear frames
4. Cutting the roof panels
5. Cutting the panel holders
6. Cutting the snow stopper
Cutting range
1. Beam cutting and processing
2. Gutter cutting and processing
Cut the materials as the same length as the cutting roof length (X) at depth direction.
Cut the materials as the same length as the cutting roof length (X) at depth direction.
In case of depth 80, cut the longer beam.
Standard
Deluxe
① Depth 31
Ｘ≦ ４８７
５９０≦Ｘ≦１０７７
１１８０≦Ｘ≦１６６７
１７７０≦Ｘ≦２２５７
③ Depth 54 ・ 61 in common
Ｘ≦ ４８７
５９０≦Ｘ≦１０７７
１１８０≦Ｘ≦１７９５
１８９８≦Ｘ≦２５１３
④ Depth 80
Ｘ≦ ６１５
７１８≦Ｘ≦１３３３
１４３６≦Ｘ≦２０５１
※ However in each case ① , ② , ③ and ④ , the cutting roof
is not available for below dimension due to the drain hole.
５０≦Ｘ≦１６０
② Depth 34 ・ 42 in common
Ｘ≦ ４８７
５９０≦Ｘ≦１２０５
１３０８≦Ｘ≦１９２３
２０２６≦Ｘ≦２６４１
12
drain hole(in case of D80)
6.
5
X 6.
5
34
X 38
6.
5
34 X 6.
5
13
X
34
38
φ5
(on U-shaped gutter)
φ5(on U-shaped gutter)
φ5
(on U-shaped gutter)
34
φ6
0
φ6
0
drain hole
(in case of D80)