SaniServ 798, Operation Manual

Page: 16 / 28

Closed Hours/Shut-Down: If the machine is turned
off during closed hours, to resume operation:
1. Set the control switch to the
"CLEANOUT" position.
2. Dispense two quarts (2 liters) of product into a
sanitized pitcher and pour it back into the mix pan.
Doing so serves as a mixing process to eliminate any
overnight separation.
NOTE: NEVER POUR FROZEN PRODUCT INTO
THE MIX PAN. LET IT MELT FIRST.
3. Set the control switch to the
"AUTO" position and
resume operation.
Mixing:
Make certain that the product is prepared per
label instructions. The machine is designed to operate
with frozen product base having a brix range of 12.5 to
14.0. To ensure consistency and quality, use a mixing
container large enough to hold 5 gallons (20 liters) with
1 gallon (4 liter) markings to allow accurate mixing of
the frozen beverage base. Stir well before adding to
the mix solution to the mix pan. Refrigerate the base
after diluting. Keep the empty gallon bottles with their
lids or caps installed and refill them with diluted base
for easy access during busy operating periods.
Filling: Always fill the machine at the start of each
day. Fresh prechilled mix will produce the best results.
Mix Pan Lid: Be sure to leave the lid in place on top of
the machine to prevent any foreign materials from
contaminating the mix.
Drip Tray: This should be removed daily and cleaned
to remove residue.
Front Plate: This component is the plastic device from
which the product is dispensed. It is designed and
made for strength and durability. However, through
improper use, it can be damaged. Use the following
information for proper care.
1. Do not lubricate the large o-ring on the rear of the
front plate. If lubricated, it will not seal properly and
product will leak from the front plate (Fig. 33).
2. Do not over tighten the knobs.
3. Always tighten the front plate knobs evenly. Do
not attempt to turn one knob all the way down and then
the other(s). Doing so will bind the front plate and
result in breakage.
4. Improper installation of the stator rod can cause
breakage. The stator rod must be properly seated in
the dasher before installing the front plate. If the stator
rod is improperly installed, subsequent tightening of the
knobs will break the front plate.
5. Do not attempt to wash the front plate or any other
machine components in a dishwasher.
Mix Out Light: When the mix out light comes on, fill
the mix pan. The mix pan must be filled immediately to
prevent air from entering the freezing cylinder. If air
enters the freezing cylinder, it will create the condition
known as “starving the machine”, causing freeze-up
and vibration. If this condition occurs, set the control
switch to the
"OFF" position and add mix to the
mix pan. Allow the freezing cylinder to refill and return
the control switch to the
"AUTO" position.
HELPFUL HINTS
Helpful Hints
PAGE 11