SBOX-5002 - User Guide, Rev. 1.0
// 43
8/
Starting Up
The SBOX-5002 must be only operated with the nominal voltage of 19 V DC of type
SELV. For details refer to the chapter 10/ “Technical Specifications”.
8.1.
Connecting to DC Power Supply
The DC power input jack (Figure 2, pos. 1) is located on the rear side of the SBOX-5002. The SBOX-5002 will be
connected to a AC-to-DC power adapter via the male DC power plug and corresponding power cable attached to the
adapter.
Before using your system, become familiar with the system components and check that
everything is connected properly. Following a proper cabling procedure will prevent a
false power-on condition, which could result in unit operational failure.
When you install/disconnect the unit, the functional earth connection must always be
made first and disconnected last.
Also, it is recommended that the last connections attached to the system should be the
power wires!
The SBOX-5002 must be connected DC power supply complying with the SELV (Safety
Extra Low Voltage) requirements of EN 60950-1 standard. It must be observed that
wiring and short-circuit/overcurrent protection is performed according to the
applicable standards, regulations and respect to the electrical specification of the
SBOX-5002.
Even when the system is turned off via the power button (Figure 1, pos. 1) parts of the
system are still energized.
The disconnecting device (fuse/circuit backer) rating must be in accordance with the
wire cross-section and the rated current of the SBOX-5002.
The cables must have some form of support so as to minimize the strain on the unit’s
connectors.
To connect the SBOX-5002 to a corresponding DC power supply, please perform the following steps:
1.
Connect the power adapter cable to the DC jack (DC IN, Figure 2, pos. 1) of the SBOX-5002.
2.
Connect the power cable to the power adapter.
3.
Connect the power cable to a power outlet.
4.
Press the power button (Figure 1, pos. 1) on the front panel to turn on the system.