COMe-mEL10 - User Guide Rev. 1.1
// 78
Sub-screen
Next Level Sub-screens / Description
PCH-IO
Configuration>
(continued)
HD Audio
Configuration>
(continued)
HD Audio Advanced
Configuration>
(continued)
iDisplay Audio
Link
Frequency>
Selects iDisplay Link frequency
[48 MHz, 96 MHz]
iDisplay Audio
Link T-Mode>
Indicates whether SDI is operating in
1T, 2T (CNL) or 2T, 4T, 8T mode (ICL)
[2T Mode, 4T mode, 8T Mode, 16T
Mode]
Sub-screen
Next Level Sub-Screens / Description
PCH/IO
Configuration>
Serial IO
Configuration>
UART1 Controller
(COMe UART0>
If device is function 0, PSF disabling is skipped. PSF
default remains and device PCI CFG space will be
visible. This is needed to allow PCI enumerator access
functions above 0 in a multifunction device. The
following devices depend on each other:
I2C0 and I2C1,2,3
UART0 and UART1, SPIO, 1
UART2 and I2C,5
UART 0 (00:30:00) cannot be disabled when: Child
device is enabled like CNVi Bluetooth
(\_SB.PC00.UA00.BTH0)
UART 0 (00:30:00) cannot be enabled when: I2S Audio
codec is enabled
[Disabled, enabled, Communication port (COM)]
UART2 Controller
(COMe UART1>
Set UART2 mode
-DBG used for BIOS log print and/or Kernel OS debug
-COM-16550 Compatibility serial power with power
gating support
[Disabled, enabled, Communication port (COM)]
Serial IO UART1
Settings>
Hardware
Flow
Control>
Enable: configures two additional GPIO
pads for use as RTS/CTS signals for
UART
[Enabled, Disabled]
DMA
Enable>
Enable: UART OS driver uses DMA when
possible
Disable: OS driver enforces PIO mode
[Enabled, Disabled]
Serial IO UART2
Settings>
Hardware
Flow
Control>
Enable: configures two additional GPIO
pads for use as RTS/CTS signals for
UART
[Enabled, Disabled]
DMA
Enable>
Enable: UART OS driver uses DMA when
possibleDisable: OS driver enforces PIO
mode [Enabled, Disabled]
Sub-screen
Next Level Sub-Screens / Description
PCH/IO
Configuration>
SCS
Configuration>
eMMC 5.1 Controller>
[Enabled, Disabled]
eMMC 5.1 HS400
Mode>
[Enabled, Disabled]
