– 45 –
(2) Editing the intermediate presser height
Press STEP SEWING button
A
on the sewing screen to
display the step sewing screen.
The sewing shape is displayed at the center of the screen. The
current point, sewing start position and sewing end position
are respectively represented by (pink circle), (blue dot) and
(pink dot).
Press MODE SELECT button
B
to select the intermedi-
ate presser mode.
When ONE-STITCH BACKWARD button
C
or FOR-
WARD button
D
is pressed, the feed (current point )
moves backward or forward by one stitch. When two or more
commands have been entered, the feed position does not
change but the command display
A
is moved forward and
backward. When you keep pressing the button
C
or
D
, the
moving speed increases.
Indicated value
B
is the absolute value (Intermediate press-
er height value + Intermediate presser height increased/de-
creased value).
When COMMAND SEARCH FORWARD button
E
or
BACKWARD button
F
is pressed, the feed moves for-
ward or backward from the current point to reach the needle en-
try point where the first intermediate presser command is found.
To stop the feed, press button
C
,
D
,
E
,
F
,
G
or
H
.
When INTERMEDIATE PRESSER button
G
is pressed,
the intermediate presser is raised or lowered. (This button is
not displayed when MEMORY switch U103 is set at 0 (zero).)
When PRESSER INITIAL POSITION button
H
is
pressed, the work clamp moves to its origin and the screen is
restored to the sewing screen.
When COMMAND DELETE button
I
is pressed, the
screen for deleting the command as shown in
A
is displayed.
When
J
is pressed, the intermediate presser height
increase/decrease input screen is displayed. Input a desired
value on this screen using numeric keypad and +/- keys
K
.
When ENTER button
L
is pressed, the data is confirmed.
1. When checking the needle, or performing the feed
forward or backward, the machine fails to work un-
less the presser is lowered. Use the machine after
lowering the presser.
2. When the intermediate presser rests at its lower position,
the movement of the intermediate presser and needle
differ depending on the setting of MEMORY switch U103.
3. When increasing the height of intermediate presser
or making the needle size thicker, confirm the clear
-
ance between the wiper and the components. Wiper
cannot be used unless the clearance is secured. In
this case, turn OFF the wiper switch, or change the
set value of memory switch U105.
"II-3. MEMORY SWITCH DATA LIST" p.97
for
the memory switch settings.
A
B
I
A
B
J
D
G
E
H
C
F
L
K