7
CONTROL ERROR ROUTINE
If the ENTER button is activated at the "CTRL" prompt the VMC will display the kind of
control error, possible error is:
"DS"
Door switch,. the door was opened for more than 1 hour, this is considered
as a door switch not working well.
"COM M" Unable to communicate with motor board of master machine
"COM S" Unable to communicate with motor board of slave machine
"COM L" Unable to communicate with lift slave board, communication problem, lift not
installed.
"LIFT"
The lift movement is not working correctly, could be motor blocked, motor
encoder not working, micro switch for 0 position not detected, or micro switch
of delivery position not detected.
After clearing VMC will display the next existing error or "NONE" if no other error.
Activation of HOME button will return the VMC to the code level at the "EROR" message.
SELECTION SWITCH ERROR ROUTINE
If the ENTER button is activated at the "SEL" prompt the VMC will display a "SLXX"
message where "XX" indicates the first selection switch error (switch always closed).
Using the UP and DOWN buttons will cycle through all selection switch error. If the ENTER
button is pressed and held for two seconds during the display of any error code , that code
will be cleared.
After clearing VMC will display the next existing error, or "NONE" if no other error.
Activation of HOME button will return the VMC to the code level at the "EROR" message.
CHANGER ERROR ROUTINE
If the ENTER button is activated at the "CHAR" prompt the VMC will display a "CC"
message indicating a changer communication error a "TS" message indicating a tube
sensor error, an "IC" message indicating an Inlet chute blocked error (no coins sensed in
the acceptor for a supplier pre-determined number of hours, a "TJ" message indicating a
tube jam error, or a "CRCH" message indicating a changer ROM checksum error.
Using the UP and DOWN buttons will cycle through all changer error. If the ENTER button
is pressed and held for two seconds during the display of any error code, that code will be
cleared.
After clearing VMC will display the next existing error, or "NONE" if no other error.
Activation of HOME button will return the VMC to the code level at the "EROR" message.
Summary of Contents for Vendo G-SNACK
Page 1: ...G SNACK G SNACK PLUS MASTER SLAVE PROGRAMMING MANUAL...
Page 3: ...2...
