Sanden Vendo G-SNACK, Programming Manual

Page: 6 / 20

5
SERVICE ROUTINE
In the service mode, information such as sales by selection, total sales, total cash flow
through the machine, and diagnostic error codes can be accessed by using the selection
buttons and the electronic display. In addition, storage column assignments and vend
pricing can be set in this mode using the same techniques. The service mode can only be
entered when the vendor door is open and when the service mode switch is activated
(placed in the middle of the electronic board).
The selection switches are used to step through the various programming function as
described in the previous page.
After entry into the service mode the operator can select one of several routines to read
data registers or to program machine configuration information. This level is called the
code level. Each of these paths is identified by a service code. The code for the various
paths are as follows.
EROR Error routine
CPO Coin Payout Routine
TUFL Tube Fill Routine
TEST TEST Vend Routine
PASS Required a password to access on the protected menu
The password is the sequence of selection 4-2-3-1. The purpose of this
password is to prevent accidental reprogramming by the operator
CASH Cash counter routine
SALE Sales counter routine
PRIC Prices setting for master
PRICS * Prices setting for Slave
STOS Spaces to sales setting for master
STOSS * Spaces to sales setting for Slave
CON Machine configuration setting routine
CCOC Overpay routine
LANG Language selection
TIME Time and data routine
LIT Programmed switching-off of neon
SEC-M Master safety temperature setting
SEC-S* Slave safety temperature setting
PAY-S Payment system
LIFT Program lift position (optional)
VDSTP 6 weekly vending inhibit period
PREU password for preview mode
AGE C age control program
RTN Return to unprotected menu
RTN Return to normal mode door open state
* The slave menues are shown only if slave machine is enabled (see CON – C2).
P
ro
te
c
te
d
m
e
n
u